User's Manual

64
To mount two EM 100 G2 into a rack:
왘 Place the two receivers side by side onto a flat sur-
face, their bottom sides facing upwards.
왘 Align the connecting plate " over the holes in the
bottom sides of the receivers.
왘 Secure the connecting plate " to the receivers
using eight of the supplied recessed head screws
(M 3x6).
왘 Hook the two rack mount “ears”  to the front
panels of the receivers.
왘 Secure the rack mount “ears” to the receivers using
two of the supplied recessed head screws (M 3x6)
respectively.
왘 Slide the receivers into a 19” rack.
왘 Screw the rack mount “ears” tight.
When mounting only one receiver into a rack, use the
connecting bar
! instead of the second receiver.
왘 Hook the two rack mount “ears”  to the front
panel of the receiver.
왘 Secure the rack mount “ears” to the receiver using
two of the supplied recessed head screws (M 3x6)
respectively.
왘 Secure the connecting bar ! to one of the rack
mount “ears”
 using two of the supplied recessed
head screws (M 6x10).
왘 If you are not front mounting the antennas, insert
the two covering plugs
# into the antenna holes of
the connecting bar.
왘 Slide the receiver into a 19” rack.
왘 Screw the rack mount “ears” tight.
To mount the receiver’s antenna connection to the
front of the GA 2 rack adapter using the AM 2 antenna
mount:
왘 Screw the two BNC sockets $ of the BNC extension
cables to the connecting bar
! using the supplied
plain washers and nuts.
왘 Connect the two BNC connectors % to the BNC
sockets
 and  at the rear of the receiver.
왘 Slide the receiver into a 19” rack.
왘 Screw the rack mount “ears” tight.
왘 Connect the two telescopic antennas  to the two
BNC sockets
$.
왘 Pull the telescopic antennas out and align them
upwards in a V-shape.


"
!


#
%
$
!

ew100.book Seite 64 Mittwoch, 8. Oktober 2003 12:52 12