User's Manual

63
Connecting the amplifier/mixing console
The EM 100 G2’s audio outputs are available as an XLR-3M socket  and a
¼” (6.3 mm) jack socket
, allowing you to simultaneously connect two
units (e.g. amplifier, mixing console). The adjusted audio output level is com-
mon for both sockets.
왘 Connect the amplifier/mixing console to the XLR-3M socket  or the
¼” (6.3 mm) jack socket
.
For detailed information on balanced and unbalanced connection, please
refer to the section “Connector assignment” auf Seite 91.
왘 Via the operating menu, adapt the level of the audio output (AF OUT) to
the input of the amplifier or mixing console (see: „Adjusting the audio
output level (receivers only)“ on page 81).
Service interface
The service interface  is only required for servicing purposes.
19” rack adapter and antenna mount
For mounting one or two receivers into a 19” rack, you require the GA 2 rack
adapter. The GA 2 rack adapter consists of:
y2 rack mount “ears”

y1 connecting bar !
y1 connecting plate "
y2 covering plugs # for antenna holes
y12 recessed head screws M 3x6
y2 recessed head screws M 6x10
When mounting only one receiver into a rack, you can use the AM 2 antenna
mount (available as an accessory) to mount the transmitter’s antenna con-
nection to the front of the GA 2 rack adapter. The AM 2 antenna mount con-
sists of :
y2 BNC extension cables (screw-in BNC socket
$ to BNC connector %)
y2 plains washers
y2 nuts
 

!
"
#

%
$
ew100.book Seite 63 Mittwoch, 8. Oktober 2003 12:52 12