User's Manual

Prepared 10/2016 14 Patent pending
14407 Coil Plus Dr, Unit A | Plaineld, IL 60544
www.sennco.com | [e-mail]
815.577.3400 | Toll free 866.736.6261
Mon - Fri 9AM - 5PM CST
1. Find the Cordwinder. Clean the top of the Cordwinder box where the cable exits using an alcohol wipe. Dry it with a clean cloth.
2. Peel the backing o of the Cordwinder mounng adhesive and secure the adhesive to the Cordwinder. Press rmly for 15 seconds for a
stronger adhesive bond.
3. Using an alcohol wipe, clean the area underneath the xture where the Cordwinder will be placed. Dry with a clean cloth.
4. Peel the backing o of the top of the adhesive and secure the Cordwinder to the underside of the xture so that the cable is centered in the
cradle mounng plate. Press rmly for 15 seconds for a stronger adhesive bond.
5. Pull the cable end up through the large hole in the cradle mounng plate and guide the cable into the slot on the center post of the cable
mounng plate. Slowly allow the cable to retract unl the cable rests on the center post.
6. Find the power cable for the cradle and pull the barrel plug end up through the large hole in the cradle mounng plate.
7. Plug the power cable into the power port on the boom of the cradle.
8. Guide the power cable into the cable keeper.
9. Make sure that the mouse hole is towards the back of the xture.
10. Place the cradle on top of the cradle mounng plate, oset slightly counterclockwise from center.
11. Turn the cradle clockwise unl it locks in place.
12. Plug the power cable into an outlet that has AC power available.
Cradle mounng connued (following mounng opon 1, 2, 3, or 4)