User's Manual

Prepared 10/2016 11 Patent pending
14407 Coil Plus Dr, Unit A | Plaineld, IL 60544
www.sennco.com | [e-mail]
815.577.3400 | Toll free 866.736.6261
Mon - Fri 9AM - 5PM CST
III. Set Up
A. Cradles
Note: Main Alarm, Cloud Interface, and cradles should be located at the same height as much as possible.
1. Clean the at side of the cradle mounng plate using an alcohol wipe. Dry with a clean cloth.
2. Remove the backing from one side of the cradle mounng plate adhesive.
3. Apply the adhesive to the at side of the cradle mounng plate. Make sure that the cutout on the adhesive is lined up with the cutout in the
paern on the mounng plate. Press rmly for 15 seconds for a stronger adhesive bond.
4. Using an alcohol wipe, clean the surface where the cradle will be placed.
Cradle mounng opon 1: Mounng plate using adhesive (no wedge)
5. Remove the remaining backing from the adhesive.
6. Center the cradle mounng plate over the posion. The slot in the center post of the cradle mounng plate should be open at the top and
the large opening in the cradle mounng plate should be at the top le. Press rmly for 15 seconds for a stronger adhesive bond.