operation manual

6 WWW.SENIXTOOLS.EU
MAINTENANCE AND STORAGE
1. Disconnect the product from the
power supply(i.e. remove the plug
from the power supply or the battery
pack)and check for damage after
use.
2. Disconnect the product from the
power supply (i.e. remove the
plug from the power supply or the
battery pack) before carrying out
maintenance or cleaning work.
3. Use only the manufacturer’s
recommended replacement parts
and accessories.
4. Inspect and maintain the product
regularly. Have the product repaired
only by an authorised service centre
or similar qualified specialist.
5. When not in use, store the product
out of the reach of children.
VIBRATION AND NOISE REDUCTION
To reduce the impact of noise and vibration
emission, limit the time of operation, use
low-vibration and low-noise operating
modes as well as wear personal protective
equipment.
Take the following points into account to
minimize the vibration and noise exposure
risks:
1. Only use the product as intended by its
design and these instructions.
2. Ensure that the product is in good
condition and well maintained.
3. Use correct application tools for the
product and ensure they in good
condition.
4. Keep tight grip on the handles/grip
surface.
5. Maintain this product in accordance
with these instructions and keep it well
lubricated (where appropriate).
6. Plan your work schedule to spread any
high vibration tool use across a number
of days.
EMERGENCY
Familiarise yourself with the use of this
product by means of this instruction
manual. Memorise the safety directions
and follow them to the letter. This will help
to prevent risks and hazards.
1. Always be alert when using this
product, so that you can recognise and
handle risks early. Fast intervention
can prevent serious injury and damage
to property.
2. Switch off and disconnect from
the power supply if there is any
malfunction. Have the product checked
by a qualified specialist and repaired,
if necessary, before you put it into
operation again.
INTENDED USE AND NON-INTENDED
USED
This electric grass trimmer is only intended
to be used for cutting grass and light
weeds,edging and decorative trimming
around trees, fences, etc. in domestic
gardens. This product should not be used
to cut heavier weeds, brush, unusually
thick grass or vegetation, wet grass or to
shred leaves etc.Do not use it for others
purposes.
RESIDUAL RISKS
Even if you are operating this product in
accordance with the provisions, residual
risks will always still remain. The following
dangers can arise in connection with the
structure and design of this product:
1. Health defects resulting from vibration
emission if the product is being used
over longer period of time or not
adequately managed and properly
maintained.
2. Injuries and damage to property to
due to broken accessories or hidden
objects that are suddenly dashed.
3. Injuries and damage to property to due
to thrown and fallen objects.
4. Prolonged use of this product expose
the operator to vibrations and may
produce ‘whitefinger’ disease. In order
to reduce the risk, please wear gloves