operation manual

12 WWW.SENIXTOOLS.EU
OPERATION
Do not allow familiarity with this product to make you
careless. Remember that a careless fraction of a
second is sufcient to inict serious injury.
Always wear eye protection along with hearing
protection. Failure to do so could result in objects
being thrown into your eyes and other possible serious
injuries.
Do not use any attachments or accessories not
recommended by the manufacturer of this product. The
use of attachments or accessories not recommended
can result in serious personal injury.
WARNING:
WARNING:
WARNING:
SWITCHING ON AND OFF
Hold the product as in working condition.
To start the product, press the switch trigger.
To switch the product off, release the switch trigger.
• Stand in the operating position (Fig. 6). Stand up
straight. Do not bend over.
• Keep feet apart and rmly planted.
• Hold the shaft grip with the right hand. Keep the right
arm slightly bent.
• Hold the handle with the left hand. Keep the left arm
straight.
• Hold the unit at waist level.
• Position the cutting head a few inches above the
ground.
• Do not over-reach; Keep all parts of your body away
from the rotating cutting attachment and hot surfaces.
• To direct clippings away from you, whenever possible
swing the trimmer in a left to right cutting motion.
There is an embossed arrow on the top of the safety
guard indicating the preferred left to right direction of
trimmer operation.
Always wear eye, hearing, hand, foot and body
protection to reduce the risk of injury when operating
this unit. Keep all parts of your body away from the
rotating cutting attachment and hot surfaces.
WARNING:
HOLDING THE UNIT
When trimming around trees, posts, fences, etc., rotate
the whole unit so that the cutting head is at a 30° angle
to the ground (Fig. 6).
Maintaining the Trimming Line
Hard surfaces, such as sidewalks, can cause the
trimming line to wear down quickly or break.
• Frequently check the trimming line length. Replace
the trimming line as needed. Refer to Replacing the
Trimming Line.
• DO NOT force the unit. Make shallow cuts in as many
passes as are necessary to achieve the desired
depth. Cut at a slow, even pace.
Avoid hot surfaces by always keeping the tool away
from your body.
• Cut all grass from top to down. This will prevent grass
from wrapping around the shaft housing and string
head which could cause damage from overheating.
• If grass becomes wrapped around the string head,
STOP THE PRODUCT, remove the battery pack, and
remove the grass.
• Use the tip of line to trim grass; do not force string
head into uncut grass.
Avoid trees, owers, stones, walls and other objects
which can cause the line to break.
• Check and feed the line regularly to maintain full
cutting width and performance.
DECORATIVE TRIMMING
TRIMMING TIPS
Fig. 5