User's Manual

Local Operations

Reset the hub: The hub has to be reset when changing Wi-Fi

networks. Press and hold the white round button on the side of the

hub for at minimum eight seconds and then release it, the middle

blue signal indicator light on the front of the hub should flash eight

times if the reset is successful. Wait for up to 30 seconds for the

indicator light to steady.

Rejoin wireless network from the bulb: Power cycle the bulb (off

then back on) five times quickly. The bulb will blink two times

indicating network rejoin.

Reset factory default for the bulb: Power cycle the bulb (off then

back on) quickly for at minimum ten times. The bulb will blink five

times indicating pairing mode.

EZ-Mode commissioning from the bulb: Power cycle the bulb (off

then back on) seven times quickly to enable EZ-Mode. The bulb will

blink to indicate that it is in this mode for three minutes. To exit this

mode earlier, power off the bulb via the wall switch, wait for two

seconds and then power it back on.

*To ensure the following steps work successfully, please power

on the bulb first and wait for at least four seconds before taking

any of the steps.

System Setup Instructions

•

Please review the Quick Start guide for instructions on how to

set up the Element Hub

Please contact customer service via Sengled.com for

information on how to purchase additional bulbs. To add

additional bulbs, please follow the in-app instructions to scan,

power on and add the bulbs to their desired hub as shown below