User's Manual

SENDUM WIRELESS, CORP.
3.2 Installing the Battery
Slide the battery pack into the PT200 battery slot using the guiding tabs until the latch
clicks into place.
3.3 Removing the Battery
Pull the latch and slide the battery pack away from the PT200 housing at the same time.
3.4 Charging the Battery
New batteries are shipped partially charged. Before you can use your device, install and
charge the battery as described below. Some batteries perform best after several full
charge/discharge cycles.
3.4.1 Charging using the PT200 Device
Simply attached the Sendum charger into the device and plug the AC adapter to the AC
outlet.
3.4.2 Charging using Gang Charger
Attached the battery pack to the Sendum external charger slot.
4 Provisioning Your Device
Ø Connect your device using the sendum USB cable. If problem communicating
with the device. Use the following documents for troubleshooting:
DEX00003 (DOC
QUALCOMM USB DRIVER INSTALLATION).doc
Ø Open the Sendum Provisioning Tool. Should look like: