Operation Manual

58 Sendo X User Guide
5
Contacts
! To assign default numbers and addresses
1. Open the required contact card, or create a new
one, as shown above.
2. Press Options g and select Defaults.
3. Use the joypad to scroll to the field you want to
assign, for example Phone number, and press
Assign g.
4. Scroll through the list of numbers or addresses
shown, and highlight the one you want to set as
the default.
5. Press Select .
z Note: When you view the contact card again,
the default phone number, address, etc., which
you have set up will be underlined.
! To add a thumbnail image to a contact card
1. Open the required contact card, or create a new
one, as shown above.
2. Press Options g and select Edit.
3. Press Options g again and select Add
thumbnail.
4. The thumbnail images stored in your Photo
Album will be displayed - use the joypad to scroll
through them and press Select  to choose the
thumbnail to attach.
z Note: When you have attached a thumbnail
image to a contact card, if that contact calls
your phone, the image will be displayed on the
Incoming Call screen next to the contact’s
name.
! To assign a ring tone to a contact card
1. Open the required contact card, or create a new
one, as shown above.
2. Press Options g and select Ring tone.
3. A list of available ring tones will appear - scroll
to the one you want to choose, and press
Select .
z Tip: To remove an assigned ring tone from a
contact card, press Options g and select Ring
tone, then select Default tone from the list.
z Note: You can assign a ring tone to a group of
contacts. See Creating Contact groups on
Page 59. If a contact has been assigned two
different ring tones, one individually, and one as
part of a contact group, whichever was
assigned most recently will be used.
Shortcuts to calling a contact
If your Contacts directory is very long, having to
scroll through pages of names to find a contact is
inconvenient. There are a number of shortcuts
available from the Now! screen to make it quicker
for you to call a contact.
! To call a contact using voice dialling
1. Press and hold the Voice key t.
2. When prompted, say the command “Name
Dial” clearly into the microphone.
3. When prompted, say the name of the contact
you wish to call, clearly into the microphone. You