User's Manual

52
3.2.6 Configure the RB as Remote Wireless Bridge
The RB series can easy build out Point-to-Point, Point-to-Multipoint wireless
backbone infrastructure, you can configure your RB as the Remote Wireless
Bridge that connect to the Central RB.
Configure the operation role of this RB (as shown in Figure 3-12)
1. Click Quick Config, select Remote Wireless Router/Bridge to setup
this RB that play the Remote RB role and then click NEXT at the bottom
of this page to complete the modification of this page.
2. Configure the operation mode of this Remote RB (as shown in Figure 3-
13). Click Quick Config, select Remote Wireless Bridge to setup this
Remote RB that in the Bridge mode and then click NEXT at the bottom of
this page to complete the modification of this page.
3. Configure TCP/IP parameters (as shown in Figure 3-14)
In this page, enter the Bridge interface IP (default is 192.168.2.1) and
Bridge interface Net Mask (default is 255.255.255.0) that are suitable
for your network, and then click NEXT at the bottom of this page to
complete the modification of this page.
4. Configure Wireless parameters (as shown in Figure 3-15)
In this page, enter the Channel (default is 1), rts Threshold (default is
250), frag Threshold (default is 1600), SSID (default is wireless) and
Station Name (default is ap) that are suitable for your radio network and
then you can clicked radio button to disable WEP or enable 64/128 bit
WEP services (default is disable), if WEP is enabled, you must input
corresponded Default Key index and WEP Key. After that, click NEXT
at the bottom of this page to complete the modification of this page.
Hint: Make sure the SSID parameter is same with the configuration
of the Central RB.
5. Preview the configured setting of this RB (as shown in Figure 3-16)
This page will present the current settings of the RB to system
administrator, the operator can easy to view all running configuration in
here. After that, click Save button to store the changes to the RB.
53
3.3 Configure Wireless related parameters
3.3.1 Configure IEEE 802.11b WLAN parameters
Click Basic Config, select Wireless LAN page (as shown in Figure 3-17).
In here, enter the Channel (default is 1), rts Threshold (default is 250), frag
Threshold (default is 1600), SSID (default is wireless) and Station Name
(default is ap) that are suitable for your radio network and then you can
clicked radio button to disable WEP or enable 64/128 bit WEP services
(default is disable), if WEP is enabled, you must input corresponded Default
Key index and WEP Key. After that, click FINISH at the bottom of this page
to complete the modification of this page.
Figure 3-17