User's Manual

Figure 3-13

3. Configure TCP/IP parameters on Wireless (as shown in Figure 3-14)

In this page, enter the Wireless interface IP (default is 192.168.1.1)

and Wireless interface Net Mask (default is 255.255.255.0) that are

suitable for your wireless network, and specify the Default Gateway

(Default is 192.168.2.254) as the Wireless IP Address of the Central RB.

After that, specify the IP address of the DNS servers provided by your

ISP in the DNS server (Default is 192.168.2.254) parameter.

Hint: Designed your network infrastructure and assigned the

correct IP address for the Central RB and the Remote RB.

4. Configure TCP/IP parameters on Ethernet

Specify the Ethernet IP address (default is 192.168.2.1) and Ethernet

Net Mask (default is 255.255.255.0) of the Ethernet interface that is

suitable for your Ethernet network. At finally, click NEXT at the bottom of

this page to complete the modification of this page.

Figure 3-14

5. Configure Wireless parameters (as shown in Figure 3-15)

In this page, enter the Channel (default is 1), rts Threshold (default is

250), frag Threshold (default is 1600), SSID (default is wireless) and

Station Name (default is ap) that are suitable for your radio network and

then you can clicked radio button to disable WEP or enable 64/128 bit

WEP services (default is disable), if WEP is enabled, you must input

corresponded Default Key index and WEP Key. After that, click NEXT

at the bottom of this page to complete the modification of this page.

Hint: Make sure the SSID parameter is same with the configuration

of the Central RB.