User's Manual
ii
3.3.2 Security.................................................................................54
3.3.3 IEEE 802.1x Access Control ..................................................55
3.3.4 MAC based Access Control....................................................57
3.4 CONFIGURE DHCP SERVER ............................................................ 58
3.5 CONFIGURE VIRTUAL SERVER ..........................................................59
3.6 ADVANCED CONFIGURATION.............................................................61
3.6.1 Configure Routing Table .........................................................61
3.6.2 Configure Bridge ....................................................................63
3.6.3 Configure SNMP ....................................................................64
3.6.4 Configuration Review and Apply the New Settings.................... 66
3.7 UTILITY ........................................................................................ 68
3.7.1 System Info...........................................................................68
3.7.2 Software Upgrade ..................................................................69
3.7.3 Wireless Link Info..................................................................70
4. TELNET CONFIGURATION ........................................................71
5. SPECIFICATIONS.......................................................................85
6. DEFAULT SETTINGS .................................................................86
6.1 BASIC CONFIGURATION ................................................................... 86
6.1.1 System..................................................................................86
6.1.2 Interface................................................................................86
6.1.3 Telnet/Console.......................................................................88
6.1.4 ISP........................................................................................88
6.1.5 DHCP....................................................................................89
6.1.6 Virtual Server Mapping...........................................................91
6.1.7 NAT (Network Address Translation)........................................91
6.1.8 Wireless LAN ........................................................................92
6.2 ADVANCE CONFIGURATION .............................................................. 93
6.2.1 Bridging................................................................................. 93
6.2.2 SNMP Community .................................................................94
6.2.3 SNMP Trap............................................................................94
6.3 UTILITY ........................................................................................ 95
6.3.1 Software Upgrade ..................................................................95
7. REGULATORY COMPLIANCE INFORMATION ............................96
1
Chapter 1. Hardware Installation
This chapter describes the procedures for installing the Outdoor
Router/Bridge.
Note: Before you mount the Router/Bridge to a mast or on the side of
a building, be sure to configure and test the device first.
1.1 Before You Start
After unpacking the system, make sure the following items are present and in
good condition.
1. Router/Bridge
2. Inline Power Injector
3. AC Power Cord
4. MIL-C-5015 style RS232 Console Port Cable
5. Grounding Wire
6. Cross over Ethernet Cable
7. Reverse Polarity-N Female RF Cable
8. 30M MIL-C-5015 style Ethernet Cable
9. Mast Mounting Kit
10. Wall Mounting Kit
11. User’ s Manual Disk
12. Simple Spanner
2
3
4
5
6
7
8
9
10
11
12