User's Manual

48
Chapter 5. Specifications
General
Compatibility Fully interoperable with IEEE802.11b
compliant products
Regulation Certifications FCC Part 15, ETSI 300/328
Power Supply
Output: –
48 VDC/0.7A (power over
Ethernet)
Input: 100/240 VAC; 50/60 Hz
Temperature Range -20 to 70 ℃ (operating)
-40 to 80 ℃ (storage)
Humidity (non-condensing) 5% to 95% typical
Surge Arrester 20KA Surge Current
Radio
Frequency Band 2.4 – 2.484 GHz
Radio Type Direct Sequence Spread Spectrum
(DSSS)
Modulation CCK (11, 5.5Mbps)
DQPSK (2Mbps)
DBPSK (1Mbps)
Operation Channels 11 for North America, 14 for Japan,
13 for Europe, 2 for Spain, 4 for France
RF Output Power 28dBm typically
RF Connector Proprietary N-type (Reverse Polarity)
Network Information
Ethernet Interface 10-Base T (RJ45)
IP Sharing Supports NAT
Roaming Seamless roaming (IEEE802.11b
compliant)
Security 64/128-bit WEP data encryption
Management
Local Configuration RS-232 serial port
Remote Configuration HTTP, Telnet, SNMP
Firmware Upgrade Upgrade via Serial Interface or TFTP
IP Auto-configuration Supports DHCP server
Physical Specifications
Dimensions 245(L) mm x 200(W) mm x 70(H) mm
Weight 2100 g
49
Chapter 6. Default Settings
B-1 Basic Configuration
B-1-1 System (as shown in Table B-1)
Parameter Description Default Value
Supervisor ID Supervisor’ s identity code root
Supervisor Password Supervisor’ s password root
Password Confirm Confirm the password again root
Host Name Host name for the AP HWLAN
Domain Name Domain name for the AP domain.com
Default Route IP
Address
IP address of the gateway for
default route when TCP/IP
filtering
192.168.2.254
DNS Server Parameter
DNS Server 1 Address
DNS Server 2 Address
DNS Server 3 Address
IP addresses of the DNS Servers
of your Local ISP
192.168.2.254
Table B-1
B-1-2 Interface (as shown in Table B-2)
Parameter Description Default Value
Interface No.
No.1 Wireless Interface
No.2 Ethernet Interface
No.3 PPPoE Interface
No.4 PPP Interface
Note:
1. No.3 is effective
only when No.2 is
Active.
2. Default No.3 &
No. 4 is Disable
Status
Enable or disable the
Corresponding interface
Active
IP address
IP address of the corresponding
interface. The user can use a
LAN attached (wired or wireless)
computer to configure the AP
No.1: 192.168.1.1
No.2: 192.168.2.1
No.3: 192.168.3.1
No.4: 192.168.4.1