User's Manual

38
3.11.2 Software Upgrade
1. Click Utility, select Software Upgrade page (as shown in Figure 3-22),
and then you can use TFTP to upgrade your AP. In here, you must
specify the TFTP server IP and select which file you want to upgrade it
(Program image, Web image), then click OK button to start the TFTP
upgrade process.
2. If the upgrade process is success, the AP will apply the new settings and
start rebooting right away.
Hint: You must set up a TFTP server and this server must contain one
newest image.
Figure 3-22
39
Chapter 4. Telnet Configuration
The AP is designed to operate as shipped from the factory without any
special set-up. However, it has many options and parameters that can be
changed if users have special requirements. Most of the management
functions can be accessed using TCP/IP protocol, it also configured by
Telnet/Console.
The operator can have to configure the AP through using a Telnet
session on a wired LAN attached computer. To use the Telnet session,
you can simply open a Telnet window using the IP address that has
been assigned to the AP.
1. Click Start button, select Run to open the Run dialog box. Enter telnet
192.168.2. 1(default terminal type of Telnet is VT100, default IP address
of the AP is 192.168.2.1). Then click OK as shown in Figure 4-1.
Figure 4-1.