User's Manual

32
3.8 Configure Bridge
1. Click Advence Config and select the Bridging, and then click Enable
for Bridge Function as shown in Figure 3-4. In the Bridging Parameter
window, enter the IP Address (default is 192.168.2.1) and Subnet Mask
(default is 255.255.255.0) that are suitable for your network domain.
2. You can specify the MAC address of a Wireless/Ethernet client. All MAC
entries in the MAC address table are Permitted/Blocked/Learning to
connect to the AP. In here, you can also click ADD, DELETE, MODIFY
button to maintain this MAC address table.
3. After that, click FINISH at the bottom of this page to complete the
modification of this page.
33
3.9 Configure SNMP
1. Click Advence Config and select the SNMP Community page. This
page (as shown in Figure 3-17) will present the current accessible
SNMP communities and correspond Read/Write privilege. After that,
click FINISH at the bottom of this page to complete the modification of
this page.
Figure 3-17
2. Click Advence Config and select the SNMP Trap page (as shown in
Figure 3-18). In this page, you can specify the SNMP Trap host and
correspond SNMP Trap Community in this page. After that, click
FINISH at the bottom of this page to complete the modification of this
page.