User's Manual

30
Access Interface: Indicate the translation occurs on which interface
(Wireless interface, NO. 1/Ethernet interface, NO. 2), such as NO. 2.
Protocol: Indicate which protocol (TCP/UDP) you want to translate from
outside to internal server, such as TCP.
Public Access Port number: Indicate which socket port (1 ~ 65535)
you want to translate from outside to internal server, such as 21.
Virtual Server IP address: Specify the private IP address of the internal
server, such as 192.168.1.100.
Virtual Server Port number: Specify the socket port (1 ~ 65535) of the
internal server, such as 21.
3. After that, click FINISH at the bottom of PAT page to complete the
modification for the Virtual Server Mapping.
Figure 3-15
31
3.7 Configure Routing Table
1. Click Advence Config and select the Static Route page. This page (as
shown in Figure 3-16) will present the current configuration for the
routing table. You can also click ADD, DELETE or MODIFY button to
maintain the Static Routing table (Default Routing table only contain
single routing entry: Default Route entry).
2. Every Route entry contains three parameters: Network Address,
Subnet Mask and Gateway.
Network Address and Subnet Mask: Specify the destination network.
Gateway: Indicate the forward gateway.
3. After that, click FINISH at the bottom of this page to complete the
modification of this page.
Hint: The operator must to configure correct routing settings following
the network infrastructure.
Figure 3-16