User's Manual

20
Figure 3-10
21
3.2.3 Configure the AP as a Router with dynamic IP
address Ethernet
Configure TCP/IP parameters
1. Click Advanced Config, select Bridging, and then click Disable for
Bridge Function as shown in Figure 3-4. After that, click FINISH at the
bottom of this page to complete the modification of this page.
2. Click Basic Config, select Interface (as shown in Figure 3-7), in this
page, you can click radio button and enter MODIFY to choice which
interface that you want to change it (as shown in Figure 3-8).
In interface 1, Make sure this wireless interface status is Active, enter
the Wireless interface IP (default is 192.168.1.1) and Wireless
interface Net Mask (default is 255.255.255.0) that are suitable for your
wireless network.
In interface 2, Make sure this Ethernet interface status is Active, and
other parameters will obtain automatically by DHCP from your network
environment.
Click the OK button to return to the Interface Parameter window.
Finally, you need to click FINISH at the bottom of this page to complete
the modification of this page.
Hint1: Make sure interface 3 and 4 within status: Disable.
Hint2: In order to enable NAT service, choice the NAT (PAT) in the
interface Wireless and Ethernet. For example, make sure
Ethernet interface within NAT (PAT) On and Wireless
interface is NAT (PAT) Off, it means that every
communication through the Ethernet interface needs to do
NAT transfer.
3. Click Basic Config, select DHCP (as shown in Figure 3-10) and apply
the DHCP client service running on interface 2 (Ethernet interface),
After that, click FINISH at the bottom of this page to complete the
modification of this page.