User's Manual

18
Figure 3-7
Figure 3-8
19
Hint1: Make sure interface 4 within status Disable.
Hint2: Choice the NAT (PAT) in every interfaces to enable NAT
service. For example, make sure PPPoE interface within NAT
(PAT) On and others are Off, it means that every
communications through the PPPoE interface needs NAT
transfer.
4. The AP supports PPPoE auto dial-up, please make sure your default
route is zero. In here, click Basic Config, and then select System as
shown in Figure 3-9. In the System Setup page, specify the Default
Route (Default is 192.168.2.254) is 0.0.0.0 and then click FINISH
button at the bottom of this page to complete the modification of this
page.
Figure 3-9
5. Click Basic Config, select DHCP (as shown in Figure 3-10) and make
sure the DHCP client service is in Disable. After that, click FINISH at
the bottom of this page to complete the modification of this page.