User's Manual

26
4.4 Configure SNMP
Click General Config, SNMP, and then the General Configuration – SNMP
Community Parameter screen appears. Figure 4-7 shows the current
SNMP community pool and trap host pool.
Figure 4-7 General Configuration – SNMP Community Parameter
4.4.1 Configure Community Pool
The SNMP Community Pool has five entries.
1. To modify a entry, click the select button beside the entry index
number and then click
Modify , the configuration page Figure 4-8
appears.
2. Specify the Validity, Access Right and Community field.
- Validity.
Select Enable or Disable to control this community.
27
- Access Right. Select a command from the pull down menu for this field.
- Community. Enter the password related the Access Right in this field.
3. Click
OK
. To refresh the current community pool.
4. To modify another community entry to the current community pool,
repeat step 1 through step 3.
5. When you have modified all the entries you need, click
FINISH .
Figure 4-8 Modify SNMP Community Parameter
4.4.2 Configure Trap Host Pool
The Trap Host Pool has five entries.
1. To modify a entry, click the select button beside the entry index
number and click
Modify
. The configuration page Figure 4-9
appears.