User's Manual

16
4.2 System Setup
When setting up a SendFar Wireless Access Router (OWAP), you must
decide which operation mode that your OWAP works. This feature is
available in the “/General Config/System/” page.
Figure 4-1 & 4-2 show the “General Configuration – System Setup”
page.
Figure 4-1 General Configuration – System Setup-1
17
Figure 4-2 General Configuration – System Setup-2
Host Information
- Host Name. The Host Name is not an essential setting, but it helps
identify the device in network. Use this setting to assign a name to the
device.
Operation Mode
The First Thing You Have To Do
Select an operation mode, and click
FINISH
to refresh this page.
Wireless Access Bridge
Select the Wireless Access Bridge mode. And then set the corresponding
parameters.
- Bridge IP Address.
Use this setting to assign or change the bridge’s IP
address.