User Manual

SF-300CB

5/14

SendFar is the registered trademark of SendFar Technology Co., Ltd..

2. Installing and Utility

This chapter describes how to install the SF-300 Wireless Access Bridge hardware.

2.1 Hardware Description

1. Power LED

z Solid Red—Power enabled

z Off—No Power applied

2. Ethernet link/Activity LED

z Solid Green—Good LAN connection

z Off—No LAN connection

3. Radio Transmit

z Solid GREEN—Transmitting wireless data

z Off—No wireless activity

4. Interfaces of Wireless Access Bridge

z Antenna connector: Connect to 5dBi rubber antenna

z RJ-45 Ethernet port: Connect to the 10/100 base-T Ethernet network.

z RS-232 adapter: Connect to PC to configure

z DC in connector: Connect to the 24V/0.83A DC power adapter.

Users could acknowledge the device activity status from both the LED indicators on the

Ethernet Inline Power Injector and on the front panel of SF-300.

2.2 Installing the Wireless Access Bridge

The Wireless Access Bridge can be mounted in any number of locations. You can

place on wall or table. We recommend you perform a sits survey to determine a proper

placement for your Access Point.

To ensure the best performance:

z Place the Wireless Access Bridge as high and as middle as possible (relative to

the AP in the vicinity).

z Do not conceal the Wireless Access Bridge.

z Only connect the antenna that we provided to you and screw it tightly.

2.3 Mounting the Wireless Access Bridge on a wall

[Blank]