User Guide

Quick Start Guide MRD 7000
Form 8176B Version 1.3 – Aug. 2022 Page 3
Figure 4: MRD 7000 Console Screen
The eth0 and eth1 IP addresses are shown on the initial main menu. If the IP
addresses are not shown or they are to be changed, press the ENTER key on
the keyboard to advance to the next menu.
The next screen allows configuration of both global network settings and the
configuration of any of the eth ports. Select Configure Networks to change the
host name, default gateway or DNS settings. Select eth0 Adapter Status to
change the IP mode (static/DHCP), IP address, netmask, or gateway for eth0.
Select the other Adapter Status selections to configure the other eth ports.
Configure the networks settings to be appropriate for your network and consult
the full user manual if more instructions are needed.
Once the network ports are configured, press ESC to return to the main menu.
Verify that the correct IP address is displayed for eth0 or eth1. A reboot is not
necessary for the settings to be applied
Figure 5: MRD 7000 Console Configuration Screen
Connect to the Web User Interface of the MRD 7000
Launch a web browser application on the management PC. The following web
browsers are supported:
• Microsoft Edge
• Microsoft Internet Explorer 9 or higher
• Mozilla Firefox
• Google Chrome
Type the management IP address of the MRD 7000 in the browser URL field and
press ENTER. The MRD 7000 login screen will be displayed. The default user is
admin and the default password is mpeg101. Click Login to continue.
Figure 6: MRD 7000 Web UI Login Screen