User manual

MRD 3187B User Manual
Page 98
MPEG/IP 1-4 1
►Receive: Enable
Phys Conn: Port 1
Ip: 239.192.0.1
MPEG/IP 1-4
Active Group:1
►Receive 1
Receive 2
MPEG/IP 1-4 1
►Ip: 239.192.1.50
Dest Port: 01050
FEC: Disable
MPEG/IP 1-4 1
Ip: 239.192.1.50
►Dest Port: 01050
FEC: Disable
physical connector on the card), then press the
button to save the selection.
Receive 1
This section allows the user to setup the receive
function of the first receive group.
1. Use the and buttons to move the
cursor to, “Receive 1” then press the
button.
2. Use the and buttons to move the
cursor to, “Receive:” then press the
button.
3. Use the and buttons to Enable or
Disable “Receive,” then press the
button to save the selection.
4. Choose the physical connector, “Port1” or
“Port 2” then press the button.
IP
1. Use the and buttons to move the
cursor to, “IP:” then press the
button.
2. Use the and buttons to select
the column to edit and use the and
buttons to change the IP, then press
the button to save the selection.
Note: A Unicast or Multicast IP address may be
chosen.
Unicast: X.X.X.X – 223.255.255.255
Multicast: 224.0.0.0 – 239.255.255.255
Suggested Multicast Range: 239.192.X.X
Destination Port
1. Use the and buttons to move the
cursor to, “Dest Port:” then press the
button.
2. Use the and buttons to select
the column to edit and use the and
buttons to change the port (1025 –
65536), then press the button to save
the selection.