User manual

MRD 3187B User Manual
Page 97
Input
►MPEG/IP 1-4
QPSK 2-2
MPEG/IP 1-3
►Active Group:1
Receive 1
Receive 2
MPEG/IP 1-3 Net
0.0.0.0
MAC Address
► 000000000000
Input
►Active Input
Backup Mode
Input Modules
Active Input
Active Input:
► MPEG/IP 1-4
Input
Active Input
Backup Mode
►Input Modules
MAC Address
This option will show the physical MAC
Address of the MPEG/IP card.
1. Use the and buttons to move the
cursor to, “MAC Address” to view the
MPEG/IP card’s physical MAC Address.
Input Control
To enable this card as an input use the following steps.
1. Press the button.
Note: For Configuration 2 units, select RDS1 or
RDS2, then press .
2. Select “Active Input”, then press the
button.
3. Press twice to change the active input and
use the and buttons to select the input
to make active, and press the button to save
the changes.
Configure Input
1. Press the button.
Note: For Configuration 2 units, select RDS1 or
RDS2, then press .
2. Select “Input Modules”, and press the
button.
3. Use the and buttons to move the cursor
to the “MPEG/IP” card of the specific slot (e.g.
1-4). Notice the location diagram in the upper
right corner of the screen changes as the cursor
moves by each card.
4. Press the button once to display the Status
screen for the MPEG/IP card.
5. Press the button again to display the Edit
screen for the MPEG/IP card.
6. Use the and buttons to move the cursor
to, “Active Group:” then press the button.
7. Use the and buttons to change the
selection to, “Auto, 1 or 2,” (this relates to the