User manual

MRD 3187B User Manual
Page 96
Menu
►MPEG/IP NetCfg
SMPTE 333M
System
MPEG/IP 1-4 Net
IP Address
► 10.0.0.51
Subnet Mask
MPEG/IP 1-3 Net
000.000.000.000
Subnet Mask
► 255.255.255.000
MPEG/IP 1-3 Net
255.255.255.000
Gateway
► 000.000.000.000
4.17 Dual MPEG over IP Input/ UDP Output – Option 8727
General Information
Install Location: Installs in 1-2 through 1-4 and/or 2-2
through 2-4.
I/O: (2) 10/100/1000 Auto-negotiating Base-T RJ-45 Ethernet Port
Supported Formats: Receive: UDP or RTP Multicasts and Unicasts. Transmit: UDP only
Description: This card encapsulates the TS from the bus and will transmit IP streams. It can
also take in IP streams and place them on the bus for an ASI/310M card and/or a decoder.
Up to two multicasts can be subscribed to, allowing for a backup multicast to be chosen
and two mirrored unicasts can be transmitted to allow for redundancy. The two physical
connectors can be configured independently.
Menu Control
This menu is used to setup the IP address, Subnet Mask, and Gateway for the MPEG/IP card.
These settings need to be set to proper values for the network that the MRD 3187B is being
used on. These values can usually be obtained from the local network administrator.
1. Press the button.
2. Use the and buttons to move the
cursor to, “MPEG/IP NetCfg,” then press the
button.
3. Select “Port 1” or “Port 2” and then press the
button.
IP Address/Subnet Mask/Gateway
1. Use the and buttons to move the
cursor to, “IP Address,” then press the
button.
2. Use the and buttons to select the
column to edit and use the and
buttons to change the IP, then press the
button to save the selection.
3. The cursor will now be on, “Subnet Mask”.
4. Use the and buttons to select the
column to edit and use the and
buttons to change the Subnet Mask, then
press the button to save the selection.
5. The cursor will now be on, “Gateway.”
6. Use the and buttons to select the
column to edit and use the and
buttons to change the Gateway, then press
the button to save the selection.