User manual

MRD 3187B User Manual
Page 78
Input
Dual QPSK 1-3
►Dual COFDM 1-4
Dual COFDM 1-4
►Selected I/O: no
Source: A
Input A
Input
►Active Input
Backup Mode
Input Modules
Active Input
Active Input:
► Dual COFDM 1-4
Input
Active Input
Backup Mode
►Input Modules
4.14 Dual Input COFDM Receiver – Option 8715
General Information
Install Location: Any slot except 1-1 or 2-1.
I/O: (2) 75 Female F Connectors
Supported Formats: COFDM
Description: This card will allow the MRD 3187B to receive a COFDM signal for use in
electronic news gathering (U.S.) or any COFDM Terrestrial Broadcast (DVB-T,
European) applications. Only one input may be selected at a time.
Input Control
To enable this card as an input use the following steps.
1. Press the button.
Note: For Configuration 2 units, select RDS1 or
RDS2, then press .
2. Select “Active Input”, then press the
button.
3. Press twice to change the active input and
use the and buttons to select the input
to make active, and press the button to save
the changes.
Configure Input
1. Press the button.
Note: For Configuration 2 units, select RDS1 or
RDS2, then press .
2. Select “Input Modules”, and press the
button.
3. Use the and buttons to move the cursor
to “Dual COFDM” card of the specific slot (e.g.
1-4). Notice the location diagram in the upper
right corner of the screen changes as the cursor
moves by each card.
4. Press the button once to display the Status
screen for the COFDM card.
5. Press the button again to display the Edit
screen for the COFDM card.
6. Use the and buttons to move the cursor