User manual

MRD 3187B User Manual
Page 74
Menu
Event Log
GPIO Module
►Splice Requests
Splice Req Setup 1
►Splice Req 1
Splice Req 2
Splice Req 3
Splice Request Setup
Once the Input is setup the outgoing SCTE104 messages need to be configured. Use the
following steps to configure the outgoing SCTE104 messages:
1. Press the button.
2. Use the and buttons to move the
cursor to, “Splice Requests”, and then
press the button.
3. Use the and buttons to move the
cursor to, “Splice Req 1”, and then press
the button.
4. Use the and buttons to move the
cursor to the desired field to edit, and then
press the button to edit.
5. Use the and buttons to choose the
desired values, and then press the button to
save the selection.
Note: Use steps 4-5 to edit all “Splice Req”
variables
Note: The aforementioned steps apply to the
configuration of “Splice Req 2-4” as well.
Pinout
1
GND
2
Logic Input #1
3
Logic Input #2
4
Logic Input #3
5
Logic Input #4
6
+Vcc
7
GND
8
Open-Collector Output #1
9
GND
10
Open-Collector Output #2
11
GND
12
Open-Collector Output #3
13
Relay Contact #1
14
Relay Contact #1
15
Relay Contact #2
16
Relay Contact #2
17
Relay Contact #3
18
Relay Contact #3