User manual

MRD 3187B User Manual
Page 69
SDI Anlg Video 2-1
Select Format: manual
►Format: 1920x1080i
16x9 29.97
SDI Anlg Video 2-1
Analog
► Anlg Out:RGBHV
NTSC Ped:Disabled
SDI Anlg Video 2-1
SDI
► Output 1:SD
Output 2:HD
SDI Anlg Video 2-1
Output 1:SD
Output 2:HD
► SDI Clk:Pass
1. Use the and button to move the
cursor to, “Format:” then press the
button.
2. Use the and buttons to select the
desired output format, then press the
button to save the selection.
1280x720p 16x9 50.00 1920x1080i 16x9 30.00
1280x720p 16x9 59.94 1920x1080i 16x9 29.97
1280x720p 16x9 60.00 1920x1080i 16x9 25.00
SDI Output Setup
Follow the steps in this section to set the outputs to
SD-SDI and HD-SDI.
1. Use the and button to move the
cursor to, “Output 1:” then press the
button.
2. Use the and buttons to select the
desired output format (SD or HD), then
press the button to save the selection.
Note: Repeat the steps above to change to the
desired output setting for “Output 2:”
3. Use the and button to move the
cursor to, “SDI Clk:” then press the
button.
4. Use the and buttons to select the
desired SDI Clk (Pass or Squelch), then
press the button to save the selection.
Analog Output Format
Note: If this setting is set incorrectly when using
an RGB monitor, the image will appear
green. If this setting is set incorrectly when
using a Component monitor, there will be no
video on the monitor.
1. Use the and buttons to move the
cursor to, “Anlg Out:” then press the
button.
2. Use the and buttons to select the
desired output format (RGBHV, YPbPr,