User manual

MRD 3187B User Manual
Page 68
Output
►SDI Anlg Video 2-1
Audio 2-2
SDI Anlg Video 2-1
►Video
HD SDI VANC Assign
SD SDI VANC Assign
SDI Anlg Video 2-1
►Select Format: manual
Format: 1920x1080i
16x9 29.97
4.11 Video Output (2 HD/SD-SDI, 1 RGBHV/YPbPr/Comp) – Option 8712
General Information
Install Location: This card can only be installed in
location 2-1.
I/O: (2) 75 HD-SDI Female BNC outputs, (1) 15-pin
D-sub Female analog output
Supported Formats: HD-SDI, SD-SDI, YPbPr, RGBHV, and Composite
Description: This card provides three mirrored outputs from any of the available input
option cards. Two of the outputs are any combination of HD-SDI or SD-SDI and one is
analog YPbPr/RGBHV/Composite.
Output Control
1. Press the button.
2. Use the and buttons to move the cursor
to the “HD Video” card of the specific slot (e.g.
2-1). Notice the location diagram in the upper
right corner of the screen changes as the cursor
moves by each card.
Video Settings
1. Use the and buttons to move the cursor
to, “Video,” then press the button to
display the Video Status screen for the video
output card.
2. Press the button again to display the Edit
screen for the video output card.
Select Format Setting
When in “Auto” mode, the unit will automatically pick the
format which is closest to the native format of the decoded
video in the elementary stream. When in “Manual” mode,
the format may be selected from the list of available output
formats listed under “Video Format” below.
1. Use the and buttons to move the
cursor to, “Select Format:” then press
the button.
2. Use the and buttons to select either
auto or manual mode, then press the
button to save the selection.
Video Format
Note: This menu is only available if the “Select
Format” option is set to “manual.”