User manual
MRD 3187B User Manual
Page 65
AdvPSK 2-2
►Selected I/O: no
Source: A
Input A
AdvPSK 2-2
Selected I/O: yes
►Source: A
Input A
AdvPSK 2-2
Input A
► Mod:Adv QPSK 2/3
Freq:01250.0 MHz
2). Notice the location diagram in the upper right
corner of the screen changes as the cursor moves
by each card.
4. Press the button once to display the Status
screen for the Adv-PSK card.
5. Press the button again to display the Edit
screen for the Adv-PSK card.
6. Use the and buttons to move the cursor
to, “Selected I/O:” then press the
button.
7. Use the and buttons to change the
selection to, “yes,” then press the button.
Source
This option will select which input, on the back of the
card, will be active.
1. Use the and buttons to move the cursor
to, “Source:” then press the button.
2. Use the and buttons to select which
input to be active (A, B), then press the
button to save the selection.
Input A
These settings correspond to the input on “Source A.”
Modulation Type
The ASM card can receive DVB-QPSK (
1
/
2
,
2
/
3
,
3
/
4
,
5
/
6
,
7
/
8
), Adv QPSK (
1
/
2
,
2
/
3
,
3
/
4
,
5
/
6
,
7
/
8
), and 8-
PSK (
2
/
3
,
3
/
4
(2.05),
3
/
4
(2.10),
3
/
4
(2.20),
5
/
6
,
8
/
9
)
transmission.
1. Use the and buttons to move the
cursor to, “Mod:” then press the button.
2. Use the and buttons to select
(DVB-QPSK, Adv QPSK, or 8-PSK),
then press the button to save the
selection.
Frequency A
The ASM card tunes by the L-band frequency rather than the transponder frequency or
local oscillator value. The L-band frequency is the difference between the downlink
transponder frequency and the LNB local oscillator frequency.