User manual

MRD 3187B User Manual
Page 64
Input
MPEG/IP 1-3
►AdvPSK 2-2
Input
►Active Input
Backup Mode
Input Modules
Active Input
Active Input:
► AdvPSK 2-2
Input
Active Input
Backup Mode
►Input Modules
4.10 Dual Input ASM Receiver – Option 8711
General Information
Install Location: Any slot except 1-1 or 2-1.
I/O: (2) 75 Female F Connectors
Supported Formats: DVB-S/DVB-S2
Description: This card will input a satellite L-band (950MHz – 2150MHz) signal for
demodulation of KU-band, C-band, or X-band DVB-QPSK, 8PSK, or Adv-QPSK
signals. All these modes are available using Turbo Coded forward error correction. The
DVB-QPSK mode also supports legacy DVB FEC. The symbol rate ranges from
0.256MSym/s to 30MSym/s for all modulation types. This card does not provide any
power to the dish LNB. The “Input” LED will only illuminate if the card detects
frequency, symbol rate, FEC lock (Carrier Lock), and TS sync (Sync Lock). The card
provides A and B inputs, which may be independently configured, but only one may be
active at a time.
Note: This card does not provide power to the dish LNB
Input Control
To enable this card as an input use the following steps.
1. Press the button.
Note: For Configuration 2 units, select RDS1 or
RDS2, then press .
2. Select “Active Input”, then press the
button.
3. Press twice to change the active input and
use the and buttons to select the input
to make active, and press the button to save
the changes.
Configure Input
1. Press the button.
Note: For Configuration 2 units, select RDS1 or
RDS2, then press .
2. Select “Input Modules”, and press the
button.
3. Use the and buttons to move the cursor
to the “AdvPSK” card of the specific slot (e.g. 2-