User manual

MRD 3187B User Manual
Page 51
Output
Anlg Video 1-1
►Audio 2-2
Audio 2-2
Digital Audio:
► Out1: Audio 1 – PCM
Out2: Audio 2 – PCM
4.7 Audio Output (DolbyE, AES Digital, Analog) – Option 8707A
General Information
Install Location: Any slot except 1-1 and 2-1.
I/O: (2) 75 Female BNC digital outputs, (1) 15-pin D-
sub Male analog output
Supported Formats: Raw, PCM, Dolby E
Description: This card provides parsed DolbyE compressed audio, two digital audio outputs,
and two analog audio pair outputs. It provides the audio from two audio decoder
processors. Two 8707A cards can be installed to provide Raw and PCM digital audio
outputs from four audio decoder processors (Only in Configuration 2 units for separate
inputs or Configuration 1 Dual Decoder units for the same input).
Output Control
1. Press the button.
Note: For Configuration 2 units, select RDS1 or
RDS2, then press .
2. Use the and buttons to move the cursor
to the “Audio” card of the specific slot (e.g. 2-
2), then press the button. Notice the
location diagram in the upper right corner of the
screen changes as the cursor moves by each
card.
3. Press the button one more time to move from
the Status screen to the Edit screen.
Digital Audio Settings
1. Use the and buttons to move the
cursor to, “Digital Audio: Out1:” then
press the button.
2. Use the and buttons to select the
audio decoder and output format desired
(Audio X, Raw, PCM), then press the
button to save the selection.
Note: The above steps apply to “Digital Audio:
Out2:” as well.
Note: The “X” of “Audio X,” in the step above, will be (1, 2, Off) for a Configuration 1
Single Decoder unit or any Configuration 2 unit, and it will be (1, 2, 3, 4, Off) for a
Configuration 1 Dual Decoder unit.