User manual

MRD 3187B User Manual
Page 44
Anlg Video 1-1
►Select Format: manual
Format: 1920x1080i
16x9 29.97
Anlg Video 1-1
►Video
Cmpst VBI Assignment
Overlay
Output
►Anlg Video 1-1
Audio 1-2
4.6 Video Output (1 RGBHV/YPbPr, 1 Composite) - Option 8706A
General Information
Install Location: 1-1 or (2-1 only on Configuration 2
units or Configuration 1 units with dual decoders)
I/O: (1) 75 Female BNC NTSC/PAL Composite
output, (1) 15-pin D-sub Female analog output
Supported Formats: NTSC/PAL Composite, YPbPr, RGBHV
Description: Analog only, video output card that can output either high definition or
standard definition formats. There are two outputs on the card. One BNC for composite and
one 15-pin D-sub for composite
Output Control
1. Press the button.
Note: For Configuration 2 units, select RDS1 or RDS2, then press .
2. Use the and buttons to move the cursor
to the “Anlg Video” card of the specific slot
(e.g. 1-1), then press the button. Notice the
location diagram in the upper right corner of the
screen changes as the cursor moves by each
card.
Video Settings
1. Use the and buttons to move the cursor
to, “Video,” then press the button to
display the Video status screen for the video
output card.
2. Press the button again to display the Edit
screen for the video output card.
Select Format Setting
When in “Auto” mode, the unit will automatically pick the format which is closest to the
native format of the decoded video in the elementary stream. When in “Manual” mode,
the format may be selected from the list of available output formats listed under “Video
Format” below.
1. Use the and buttons to move the
cursor to, “Select Format:” then press
the button.
2. Use the and buttons to select either
auto or manual mode, then press the
button to save the selection.