User manual

MRD 3187B User Manual
Page 38
Output
►HD Video 2-1
Audio 2-2
HD Video 2-1
►Video
SDI VANC Assignment
Overlay
HD Video 2-1
►Select Format: manual
Format: 1920x1080i
16x9 29.97
4.5 Video Output (2 HD-SDI, 1 RGBHV/YPbPr) – Option 8705/8705A
General Information
Install Location: 1-1 or (2-1, only on Configuration 2
units or Configuration 1 with dual decoders)
I/O: (2) 75 HD-SDI Female BNC outputs, (1) 15-pin
D-sub Female analog output
Supported Formats: HD-SDI, YPbPr, RGBHV
Description: This card provides three mirrored outputs from any of the available input
option cards. Two of the outputs are HD-SDI and one is analog YPbPr/RGBHV.
Output Control
1. Press the button.
Note: For Configuration 2 units, select RDS1 or
RDS2, then press .
2. Use the and buttons to move the cursor
to the “HD Video” card of the specific slot (e.g.
2-1). Notice the location diagram in the upper
right corner of the screen changes as the cursor
moves by each card.
Video Settings
1. Use the and buttons to move the cursor
to, “Video,” then press the button to
display the Video Status screen for the video
output card.
2. Press the button again to display the Edit
screen for the video output card.
Select Format Setting
When in “Auto” mode, the unit will automatically pick the
format which is closest to the native format of the decoded
video in the elementary stream. When in “Manual” mode,
the format may be selected from the list of available output
formats listed under “Video Format” below.
1. Use the and buttons to move the
cursor to, “Select Format:” then press
the button.
2. Use the and buttons to select either
auto or manual mode, then press the
button to save the selection.