User manual

MRD 3187B User Manual
Page 29
Input
►ASI+ 2-2
VSB/QAM 1-4
ASI/310M 2-3
ASI+ 2-2
►Selected I/O:no
Input
►Active Input
Backup Mode
Input Modules
Active Input
Active Input:
► ASI+ 2-2
Input
Active Input
Backup Mode
►Input Modules
4.3 High Bit Rate ASI Input – Option 8703
General Information
Install Location: Any slot except 1-1 and 2-1.
I/O: (1) 75 Female BNC Input, (1) 75 Female BNC
Loop Out
Supported Formats: ASI
Description: This card provides DVB-ASI input for MPTS up to 160Mb/sec. The maximum
TS bitrate for the card is 160Mb/sec. The output on the card is a passive loop-through
and should be terminated with a 75Ohm terminator when not in use. The card cannot be
used to provide a TS output from another TS input on the unit.
Input Control
To enable this card as an input use the following steps.
1. Press the button.
Note: For Configuration 2 units, select RDS1 or
RDS2, then press .
2. Select “Active Input”, then press the
button.
3. Press twice to change the active input and
use the and buttons to select the input
to make active, and press the button to save
the changes.
Configure Input
1. Press the button.
Note: For Configuration 2 units, select RDS1 or
RDS2, then press .
2. Select “Input Modules”, and press the
button.
3. Use the and buttons to move the cursor
to the “ASI+” card of the specific slot (e.g. 2-2).
Notice the location diagram in the upper right
corner of the screen changes as the cursor moves
by each card.
4. Press the button once to display Status
screen for the ASI+ card.
5. Press the button again to display the Edit
screen for the ASI+ card.