User manual

MRD 3187B User Manual
Page 171
Appendix B – Error List
General
Bitrate Error - The TS bitrate is not within 100 bps of 19.392 Mbps while using the 310M card, or it is greater
than 160 Mbps while using ASI.
Tuner Lock Error – The FEC is not synchronized. Data on carrier is not synchronized.
Video Unsupported Profile/Level - The video is not of a supported profile/level.
Carrier Lock Error - Cannot detect the carrier signal.
TS Rate Invalid - A burst of packets caused the receive FIFO to overflow.
Not Receiving Packets - The card is not receiving IP packets within 1 FEC period (1 second).
No TS Present Error - There is no sync byte (0x47) found in a 1 second period.
Transport Packet Error - There was an error in the transport stream.
Lock Error - A carrier cannot be found.
Low MER - The MER is lower than the threshold set by the user.
Low Level - The signal level is lower than the threshold set by the user.
System Time Event – If the unit is powered on/off, the time is manually updated, or the time server is invalid,
this event will be triggered.
CA No Entitlement Error- The user has no entitlement for the program, or the user does not want to buy the
program.
CA Need Technical Dialog Error- The application has to enter into a technical dialogue with the user before
being able to descramble (e.g. ask the user to select fewer elementary streams because the
descrambling capabilities are limited).
CA Need Purchase Dialog Error- The application has to enter into a purchase dialogue with the user before
being able to descramble (e.g. pay per view programs).
CA Resource Unavailable Error- There is not a CAS card available to descramble the stream.
CA Technical Error- The application cannot descramble the elementary stream for technical reasons (e.g. all
descrambling capabilities are already in use).
Video
Video Not Decoding Error – The decoder didn’t receive a new video frame within 3 seconds.
Video Type Error- Selected video stream format is not supported by the decoder.
Video Unknown Error – Video Decoder does not recognize the video stream.
Video Conversion Error- The video stream cannot be converted.
Invalid Output Format Error - The output format selected is invalid for the combination of incoming stream
and output card.
Incompatible Genlock Error - The Genlock Reference selected by the user is incompatible with the incoming
stream format.
Genlock Reference Error - The Genlock reference is set but there is no reference signal detected.
Audio
DolbyE Not Decoding Error - The DolbyE PID has been set but is not being decoded.
Audio (N) Not Decoding Error - Audio Decoder (N) didn’t receive a new audio frame within 3 seconds.
Audio (N) Unknown Error - Audio Decoder (N) does not recognize the audio stream.
System
Fan Error - The fan is spinning at less than 500 RPM.
Temperature Error - The temperature has exceeded 70 Celsius.
DPI Stream Type Locked Error- User is not licensed to decode the selected stream.
DPI
SCTE104 GPI Event- I2C failed to write to the splice request data to the decoder.
SCTE104 LAN Event- I2C failed to write to the splice request data to the decoder.
SCTE35 Event- Parsed transport stream and event was fired.
SCTE35 GPO Event- Relay configured by user to have an SCTE35 trigger and an SCTE35 splice_insert
message was received.