User manual

MRD 3187B User Manual
Page 152
8. In the box to the right of “Pre-Roll Time” enter the
desired amount of time, in milliseconds, after being
processed that the action will occur.
9. Then insert the “Break Duration” in tenths of seconds.
Note: The “Break Duration” ranges from 0 65535. If the
default, 0, is chosen the Injector will not set a
duration. This value is ignored if “Splice Insert
Type” is anything other than “Start Normal” or
“Start Immediate.”
10. Next is the “Avail Num” which is a field that gives an
authentication for a specific avail in the current
“Unique Program ID.”
Note: The “Avail Num” ranges from 0 to 255. If left at
default, 0, non-usage will be assumed.
11. Finally the “Avails Expected” box is the last parameter
to configure. This box indicates the specific number of
individual Avails expected within the current viewing
event.
Note: The “Avails Expected” ranges from 0 to 255. If left
at its default, 0, “Avail Num” is assumed to have no
meaning.
5.3.3 Output Setup
All of the installed output option cards
are listed under the “Outputs”
heading. This section includes the
options for the installed output cards
(e.g. Video, Audio).
Each output card can be configured by clicking on the button that is next to it. When the
button is clicked it will bring up another window, in the middle of the screen, with the
specific options for that card. Use the drop down menus and input boxes to complete the edit
form. Click the button, at the bottom of the form, to save the settings. The
current settings for any of the output cards can be verified by clicking on the button next to
the desired output.