User manual

MRD 3187B User Manual
Page 151
can be set as the PIDs that the MRD
3187B will monitor for SCTE35 events.
5.3.2.5 SCTE104 Splice Requests
To setup SCTE104 Splice Requests follow the steps below.
Note: Up to 4 SCTE104 Splice
Requests can be set up at one
time. Use the tabs at the top of
the editor to configure a different
Splice Request.
1. Click on the or
tab of the corresponding RDS that
needs to be configured.
2. Under the “Services” heading,
click on the button next to the
“SCTE104 Splice Requests”
option.
3. Next, enter the “AS Index” if one
is present, otherwise leave blank.
Note: The “AS Index” ranges from 0
to 255 and uniquely identifies the
source of the message.
4. Enter the “DPI PID Index” to specify the index to the
DPI PID that will carry the splice_info_sections.
Note: The “DPI PID Index” ranges from 0 to 65535 and is
important when there are multiple DPI PIDs
referenced by the PMT of one MPEG program.
5. Use the drop down menu to select either “Start Normal,
Start Immediate, End Normal, End Immediate, or
Cancel.”
6. Next is the “Splice Event Source.” This is a user
assigned value for the source of the cue message.
7. In the next box, enter the “Unique Program ID:”
Note: The “Unique Program ID” ranges from 0 to 65535
and is a unique identification for a viewing event in
the service.