User manual

MRD 3187B User Manual
Page 150
2. Under the “Services” heading, click on
the button next to the Source ID
option.
3. A new window will pop up in the
middle of the screen. Use the drop
down menu at the top to choose the
“Lookup Mode.”
4. Then use the next drop down box
to choose the desired “ID
Timeout” (in seconds).
5. Enter a “Manual Station Name:”
and then click the
button to save the changes.
Note: If no source is found in the allotted time
the “Manual Station Name:” is
displayed.
5.3.2.4 SCTE35
To select the PIDs for SCTE35 follow the steps
below.
1. Click on the or tab of the
corresponding RDS that needs to be
configured.
2. Under the “Services” heading, click on
the button next to the “SCTE35”
option.
3. Set the “PID Detection Mode” to
either “Auto, or Manual.”
Note: If “Manual” PID Detection Mode
is selected the following boxes
become available to configure:
“PID 1, PID 2, and PID 3.”
Note: If “Auto” mode is selected the
MRD 3187B will pick the first
three DPI PIDs in the PMT’s
registration descriptor to monitor
for SCTE35 events.
4. Next, enter the “Heartbeat Timeout:” in
minutes.
5. If “Manual” is selected in the above drop
down box, “PID 1, PID 2, and PID 3”