User manual

MRD 3187B User Manual
Page 123
Serv Setup
Tune Mode: Auto
►Number: -
RDS1 Serv Setup
Audio1 Typ :Dolby AC3
►Audio2 PID :0x0000
Audio2 Typ :---------
RDS1 Serv Setup
Audio2 PID :0x0024
►Audio2 Typ :---------
DlbyE1 PID :0x0000
1. Use the and buttons to move
the cursor to, “Audio2 PID” then press
the button.
2. Use the and buttons to select
the column to edit, then use the and
buttons to select the desired Audio
PID in the stream, then press the
button to save the PID.
Audio 2 Type
1. Use the and buttons to move
the cursor to, “Audio2 Typ” then press
the button.
2. Use the and buttons to select
the audio type on the PID chosen above,
then press the button.
Note: Repeat the steps above to setup “Audio
3 PID” and “Typ” as well as “Audio 4
PID” and “Typ.”
Auto Mode
This mode should only be used if no PID
information is known about the stream.
Auto Program
Note: This menu is only available if the “Tune
Mode” is set to “Auto”.
1. Use the and buttons to move
the cursor to, “Auto” then press the
button.
2. Use the and buttons to select
the desired program number in the
stream, then press the button to
save the selection.
Audio 1 Setup
The following menus are used to setup the audio
downmix settings.
Note: Use the following instructions to setup
Audio 1-4.