User manual

MRD 3187B User Manual
Page 118
RDS 1
►Service Setup
Sdi Aud Embed
Video Status
Serv Setup
►Tune Mode :Pid Lock
PID Select :Manual
PCR PID :0x0000
4.19 MPEG Decoder with Genlock (1 Video, 4 Audio) – Option 8733
General Information
Install Location: Not Field Upgradeable
I/O: The input and output is done through the various other I/O cards. (e.g. 8701)
Supported Formats: Option 8733 can decode MPEG-2 4.2.2, and all formats supported by
the option cards, with the exception of MPEG-4.
Description: With the 8733 decoder board the MRD 3187B can only be configured as a
Single RDS. Meaning only one MPEG Decoder. The MRD 3187B with the 8733
decoder board can be configured to process four audio streams.
Decoder Setup
To setup the MRD 3187B to be able to decode the incoming audio and video use the
following steps.
1. Press the button to bring the display back to the RDS status screen.
2. Press the or button to access the Decoder Menu.
Note: With this Decoder card the MRD 3187B can only
have one decoder so either of the or buttons
will display the same decoder menu.
3. Use the and buttons to move the cursor
to, “Service Setup,” then press the button.
4. Press the button again to display the Edit
screen for the RDS 1 Decoder.
Tune Mode
1. Use the and buttons to move the
cursor to, “Tune Mode:” then press the
button.
2. Use the and buttons to select the
desired mode (Auto, No PSI, PID Lock,
Priority), then press the button to save
the selection.
PID Lock Mode
This mode is the most desirable and will produce
the most consistent output. If possible this mode
should always be used.