User manual

MRD 3187B User Manual
Page 104
MPEG/IP 1-3
Receive 1
Receive 2
►Reset Counters
Output
HD Video 2-1
►MPEG/IP 1-4
MPEG/IP 1-4 2
Filter Mode: Include
Edit Remove
Add IP
MPEG/IP 1-4 2
239.192.20.3
Add IP
►Clear All
Note: A maximum of 64 IP addresses may be
added to the list.
Edit/Remove an IP
1. Use the and buttons to move
the cursor to the desired IP address to
edit, then press the button.
2. Use the and buttons to select
either Edit or Remove, then press the
button.
Clear All
This option will clear all IP addresses in the
filter list.
1. Use the and buttons to move
the cursor to, “Clear All,” then press the
button.
2. Press the button one more time to
clear all the IP addresses in the list.
Reset Counters
This option will reset the counters on the status
screen for the MPEG/IP card.
1. Use the and buttons to move the
cursor to, “Reset Counters,” then press the
button.
2. Press the button again to reset the
counters.
Output Control
To configure this card as an output use the following
steps:
1. Press the button.
Note: For Configuration 2 units, select RDS1 or
RDS2, then press .
2. Use the and buttons to move the cursor
to the “MPEG/IP” card of the specific slot (e.g.
1-4). Notice the location diagram in the upper
right corner of the screen changes as the cursor
moves by each card.
3. Press the button once to display the