Instruction manual

EN - 5

1. To retrieve manually the speciﬁ c sensor temperature and humidity

reading, press CH key until desired channel number is displayed

2. To enable auto-scroll function, use CH button to toggle channel

1, 2 or 3 until auto scroll icon appears on the left hand side of the

second line display.

DCF 77 RADIO CONTROLLED CLOCK

The radio-controlled time is calculated by the Cesium Atomic clock of

Braunschweig (ofﬁ cial clock of Germany).

Then the time is coded and transmitted from Mainﬂ ingen - near

Frankfurt - via a signal on DCF-77 (77.5 kHz). The transmitting

range of the signal is 500 km, which means that most of Western

and Central Europe is covered by this signal. Within this range the

received time is completely accurate. Once sensor signal(s) are

received, the wave icon

will ﬂ ash to indicate that the receiving unit starts to receive the DCF

radio controlled time signal.

RCC Mode Start RCC Received

Once the time signal is received, the wave icon will stay on the LCD,

and time and calendar will automatically be updated.

Note: During the 10-minute time signal reception, all manual settings

will be suspended. If setting is desired, press once [ MEM ] key to

deactivate the reception. You can also press and hold the same key

for 3 seconds to manually activate the reception in normal mode.

SET THE CLOCK, CALENDAR & LANGUAGE &

TEMPERATURE UNIT & RCC ON/OFF

1. Press & hold [MODE] button for 2 seconds to enter clock setting

mode. Flashing 12/24 hours will appear.

2. Press [  ] or [  ] button to switch between 24 hours and

12 hours format, and then press [MODE] button to conﬁ rm.

4. The time zone digits will ﬂ ash. Use the [  ] button to decrease by

one hour or [  ] button to increase by one hour to your desired

hour. Press [MODE] button to conﬁ rm.

Note: The range of time zone setting can be reach to ( -12 ~ +12)

5. The hour digits will ﬂ ash. Use the [  ] button to decrease by

one hour or [  ] button to increase by one hour to your desired

hour. Hold press either button will change the digit rapidly. Press

[MODE] button to conﬁ rm.

6. The minute digits will ﬂ ash. Use the [  ] or [  ] button to set

your desired minute. Hold press either button will change the digit

rapidly. Press [MODE] button to conﬁ rm.

Note: Every change of minute digit will automatically reset the

seconds to zero.