Technical data

Installation
2.2 Installing STEP 7
Programming with STEP 7
52 Manual, 05/2010, A5E02789666-01
If Errors Occur during the Installation
Setup may be cancelled due to the following errors:
• If an initialization error occurs immediately after the start of Setup, more than likely setup was
not started under Windows.
• Insufficient hard disk space: For the basic software, you require approximately 650 MB to
900 MB of free space on your hard disk depending on the scope of your installation.
• Bad CD-ROM: If the CD is faulty, please contact your local Siemens representative.
• Operator error: Restart setup follow the instructions carefully.
After the installation has been completed…
An on-screen message reports the successful installation.
If any changes were made to system files during the installation, you are prompted to restart
Windows. After this restart (warm restart) you can start the STEP 7 application, the SIMATIC
Manager.
After successful installation, a program group for STEP 7 has been set up.