Technical data

Controlling and Monitoring Variables
17.5 Transferring Configuration Data to the Operator Interface Programmable Controller
Programming with STEP 7
400 Manual, 05/2010, A5E02789666-01
17.5 Transferring Configuration Data to the Operator Interface
Programmable Controller
Introduction
Using the transfer program AS-OS Engineering you transfer the configuration data for operator
control and monitoring generated to the WinCC database.
Requirement
Before you start the transfer, the following requirements must be fulfilled:
• You have installed the program AS-OS Engineering.
• You have generated the configuration data for operator control and monitoring.
Basic Procedure
To transfer the configuration data for operator control and monitoring to the WinCC database,
proceed as follows: