SDS

Shell Corena S2 P 100
Version 2.0
Effective Date 28.10.2011
Safety Data Sheet
Regulation 1907/2006/EC
4/9
Print Date 29.10.2011 000000019518
MSDS_GB
8. EXPOSURE CONTROLS/PERSONAL PROTECTION
If the American Conference of Governmental Industrial Hygienists (ACGIH) value is provided on
this document, it is provided for information only.
Occupational Exposure Limits
Material Source Type ppm mg/m3 Notation
Oil mist, mineral ACGIH TWA
[Inhalable
fraction.]
5 mg/m3
Exposure Controls
: The level of protection and types of controls necessary will vary
depending upon potential exposure conditions. Select controls
based on a risk assessment of local circumstances.
Appropriate measures include: Adequate ventilation to control
airborne concentrations. Where material is heated, sprayed or
mist formed, there is greater potential for airborne
concentrations to be generated.
Personal Protective
Equipment
: Personal protective equipment (PPE) should meet
recommended national standards. Check with PPE suppliers.
Respiratory Protection
: No respiratory protection is ordinarily required under normal
conditions of use. In accordance with good industrial hygiene
practices, precautions should be taken to avoid breathing of
material. If engineering controls do not maintain airborne
concentrations to a level which is adequate to protect worker
health, select respiratory protection equipment suitable for the
specific conditions of use and meeting relevant legislation.
Check with respiratory protective equipment suppliers. Where
air-filtering respirators are suitable, select an appropriate
combination of mask and filter. Select a filter suitable for
combined particulate/organic gases and vapours [boiling point
>65 °C (149 °F)] meeting EN14387.
Hand Protection
: Where hand contact with the product may occur the use of
gloves approved to relevant standards (e.g. Europe: EN374,
US: F739) made from the following materials may provide
suitable chemical protection: PVC, neoprene or nitrile rubber
gloves. Suitability and durability of a glove is dependent on
usage, e.g. frequency and duration of contact, chemical
resistance of glove material, glove thickness, dexterity. Always
seek advice from glove suppliers. Contaminated gloves should
be replaced. Personal hygiene is a key element of effective