User`s manual

11b/g Wireless Multi-Client Bridge/AP Version 1.0
22
3.3.2 Infrastructure / Ad-hoc Mode
 Click on the Wireless_Setting link under the Wireless menu. The second part of
this page allows you to configure the device in infrastructure or ad-hoc mode.
 Wireless Mode: Select the Infrastructure or Ad-Hoc radio button. Infrastructure is a
point-to-multipoint (PtMp) topology where as Adhoc is a point-to-point topology (PtP).
 Wireless Network Name: The SSID is a unique named shared amongst all the
points of the wireless network. The SSID must be identical on all points of the
wireless network and cannot exceed 32 characters.
 Channel: Select a channel from the drop-down list. The channels available are
based on the country’s regulation. When selecting Infrastructure mode, a channel is
not required, however, when selecting Adhoc mode, you must select the same
channel on all points.
 Transmission Rate: Select a transmission rate from the drop-down list. It is
recommended to use the Best (automatic) option.
 802.11 Mode: Select the IEEE 802.11 mode from the drop-down list. For example, if
you are sure that the wireless network will be using only IEEE 802.11g clients, then it
is recommended to select 802.11g only instead of Mixed 802.11g and 802.11b
which will reduce the performance of the wireless network.