User Manual
Table Of Contents
- Contents
- 1 About This Getting Started Guide
- 2 Unpacking the ZoneFlex Access Point
- 3 Before You Begin
- 4 Configuring the Access Point
- Configuring for Management by ZoneDirector
- Configuring for Standalone Operation or for Management by FlexMaster
- What You Will Need
- Step 1: Prepare the Administrative Computer
- Step 2: Connect the Access Point to the Administrative Computer
- Step 3: Log Into the Access Point’s Web Interface
- Step 4: Configure the Wireless Settings
- Step 5: Disconnect the Access Point from the Administrative Computer
- Step 6: Restore the Administrative Computer’s Network Settings
- 5 Verifying Access Point Operation
- 6 Deploying the Access Point
- 7 Attaching the Mounting Brackets
- 8 Mounting the Access Point
- 9 (Optional) Mounting and Connecting the External Antennas
- 10 What to Do Next
52
(Optional) Mounting and Connecting the External Antennas
Step 2: Attach the Dynamic Bracket to the Access Point
Figure 40. Connect the RF coaxial cables to the standard N-type female connectors on
the Access Point
4. Apply weatherproofing tape to the antenna connectors to help prevent water and dirt
from entering the Access Point.
5. Reconnect the Access Point to the power source.
CAUTION: If you are not connecting external antennas to the standard N-type antenna
interfaces on the Access Point, make sure that the metal caps remains installed and
securely fastened to protect the interface from elements, such as water and dirt.
You have completed connecting external antennas to the Access Point.
Patch Antenna
Antenna
Connectors