User Manual
Table Of Contents
- Contents
- 1 About This Getting Started Guide
- 2 Unpacking the ZoneFlex Access Point
- 3 Before You Begin
- 4 Configuring the Access Point
- Configuring for Management by ZoneDirector
- Configuring for Standalone Operation or for Management by FlexMaster
- What You Will Need
- Step 1: Prepare the Administrative Computer
- Step 2: Connect the Access Point to the Administrative Computer
- Step 3: Log Into the Access Point’s Web Interface
- Step 4: Configure the Wireless Settings
- Step 5: Disconnect the Access Point from the Administrative Computer
- Step 6: Restore the Administrative Computer’s Network Settings
- 5 Verifying Access Point Operation
- 6 Deploying the Access Point
- 7 Attaching the Mounting Brackets
- 8 Mounting the Access Point
- 9 (Optional) Mounting and Connecting the External Antennas
- 10 What to Do Next
8
Before You Begin
Get to Know the Access Point Features
If you want to extend the range of your wireless network, you can connect external high
gain antennas to the standard N-type radio frequency (RF) antenna connectors on the top
panel of the Access Point. The antennas must have a gain of less than 14dBi to comply
with FCC and CE regulations. For more information, refer to “(Optional) Mounting and
Connecting the External Antennas” on page 51.
Figure 5. The antenna connectors are protected by metal caps
Metal caps