User's Manual
Table Of Contents
- Contents
- 1 About This Getting Started Guide
- 2 Unpacking the ZoneFlex Wireless Bridge
- 3 Before You Begin
- 4 Preparing the Wireless Bridge Pair for Installation
- What You Will Need
- Configure the Root Bridge
- Configure the Non-Root Bridge (Optional)
- 5 Physical Installation
- 6 Deploying the Wireless Bridge
- 7 Attaching the Mounting Brackets
- 8 Mounting the Wireless Bridge
- 9 Mounting and Connecting the External Antennas (Optional)
- 10 Aiming the Bridge Pair
- 11 Verifying the Connection
- 12 What to Do Next
5
Before You Begin
Prepare the Required Hardware and Tools
3 Before You Begin
Prepare the Required Hardware and Tools
You must supply the following tools and equipment:
■ A notebook computer running Windows 2000/XP/Vista and installed with one wireless
802.11b/g network card and one Ethernet card
■ 6mm flathead screwdriver
■ 6mm Phillips screwdriver
■ 10mm ratchet wrench
■ 3mm Phillips screwdriver (if you will be using DC power)
■ Electric drill with 8mm drill bit (if mounting on a flat surface)
NOTE: At the beginning of each procedure, this guide lists the specific tools, accessories,
and equipment that you will need to complete the procedure.
Get to Know the Hardware Features
Figure 3 and Figure 5 identify the Wireless Bridge features that are relevant to the
installation and mounting instructions that this guide provides. Before you begin the
installation process, Ruckus Wireless recommends that you become familiar with these
features.